User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration

4Motion 235 System Manual

3.3.11.12.3.2 Restoring the Default Configuration Parameters for a VLAN Service Interface

Run the following command to restore the default configuration for a VLAN service

interface tun-mtu parameter:

npu(config-srvcif-vlan)# no tunnel mtu

3.3.11.12.4 Terminating a Service Interface Configuration Mode

This section describes the commands for:

 “Terminating the IP-IP Service Interface Configuration Mode” on page 236

 “Terminating the VLAN Service Interface Configuration Mode” on page 236

 “Terminating the QinQ Service Interface Configuration Mode” on page 236

NOTE

Refer to Section 3.3.11.12.2.1 for a description and default values of these parameters.

Command

Syntax

npu(

config-srvcif-ipip)# no tunnel [mtu] [chksm]

Privilege

Level

Command

Modes

IP-IP Service Interface configuration mode

NOTE

Refer to Section 3.3.11.12.2.2 for a description and default values of this parameter.

Command

Syntax

npu(

config-srvcif-vlan)# no tunnel mtu

Privilege

Level

Command

Modes

VLAN Service Interface configuration mode