Installation Instructions Manual

- 2 - eBridge1CT
3.ConnectstructuredcablefromtheIPcamera/devicetoRJ45jackmarked[10/100BaseT](Fig. 2, pg. 3).
Connect Coax cable to BNC connector marked [Coax] (Fig. 2, pg. 3).
4. For optional simultaneous Composite Video transmission, attach the Composite Video Cable (Fig. 2, pg. 3) by
plugging the two (2) position connector into the Comp. Video input marked on the unit
(Note: connector is polarized). Connect the BNC side to the composite video output of the IP camera,
monitor display, matrix switch or other headend equipment.
Note: The eBridge is designed to accommodate Megapixel, HD720, HD1080 and VGA (SD) cameras. It is important
to note that some high resolution and high frame rate cameras may demand faster headend processing ability, such as a
PC graphics card to present a quality image. If the headend processing equipment is insufficient in speed, the image may
show pixilation and latency. It is advisable to pretest system if unsure. Alternatively, frame rate and resolution may be
reduced to accommodate system equipment.
Technical Specifications:
Parameter Description
Connections BNCforCoaxlink.RJ45forethernetlink.
Composite video connector for optional composite video service
Input power requirements 12VDC/275mA, 24VDC/110mA, 16VAC/375mA, 24VAC/200mA
Indicators Blue:CoaxLink.
Yellow(RJ45connector):On-Link,Off-NoLink,Blinking-Activity.
Green(RJ45connector):On-100Base-TX,Off-10Base-T.
Green:Power.
Environmental
Conditions
OperatingAmbientTemperature: UL60950-114ºFto122ºF(-10ºCto50ºC).
Relativehumidity:85%,+/---5%
StorageTemperature:---4ºto158ºF(---20ºto70ºC)Storage
OperatingAltitude:--- 1000 to 6,561.679 ft. (--- 304.8 to 2000m).
Regulatory Compliance UL/CUL Listed for Information Technology Equipment (UL 60950-1). CE approved
Weights (approx.) Product:4oz.(0.11 kg.), Shipping:7oz.(0.17 kg.)
Fig. 1 eBridge1CT
Optional
Composite
Video Connector
to Camera
Green LED
indicates
Power
Structured
Cable from
IP Camera/Device
Blue LED
indicates
Coax Connection
16 to 24
VAC or VDC
Input
Coax
Cable from
eBridge1CR