User`s manual

8
CH 2 CH 3
-. FADER Control
18
3.1.5 The CROSSFADER Section
Through this crossfader you can fade in between channel 2
and channel 3. The crossfader on your MX-30 is user re-
placeable.
3.2 The Front Panel
MIC IN PHONE OUT
REVERSE HOLD
REVERSE TAP
CROSSFADER
CURVE
SMOOTH
SHARP
19 20
21
22
3.2.1 MIC IN Jack
This input will accept any unbalanced low impedance microphone. The functions of the microphone will be
controlled by the CHANNEL section on the top cover.
19
3.2.2 PHONE OUT Jack
This input will accept a standard headphone with a 1/4" stereo jack
20
3.2.4 CROSSFADER CURVE Control
Via this knob you will adjust the crossfader curve. When set the knob at the SHARP position, the switching
speed between CH 2 and CH 3 will be changed quite quickly by the crossfader even if you move the fader slowly;
at the smooth position, the switching speed will be changed much more slowly by the crossfader even if you
move the fader quickly.
22
18
3.2.3 REVERSE Switch
21
This switch will invert the direction of the crossfader so that an immediate inversion of the two channels will be
achieved. This switch has two functions: TAP and HOLD.
In TAP function the both channels will be reversed instantly and will go back in their original set as soon as
you release the switch in center position
In HOLD function the both channels will be locked in the reverse position. To cancel the effect you will need to
push back the switch in the center position.