User's Manual
37
Altai A8n (ac) Series Super WiFi Base Station
Configuration Guide
Altai Technologies Ltd. All rights reserved
Preferred AP0 / AP1 / AP2 Mac [Optional] – Enter up to three AP
MAC addresses that station associates them preferentially. AP0 is
the highest priority.
Roaming Setting [Optional]
Enable Roaming - Select to enable roaming on station
Scan SNR Threshold – Enter SNR from 0dB to 100dB that station
performs channel scanning if the SNR of received signal from
associated AP is less than (<) this threshold; 35 is default setting.
Roaming SNR Threshold - Enter SNR from 0dB to 100dB that station
triggers the roaming if the SNR of received signal from associated AP
is less than (<) this threshold; 30 is default setting.
Note:
- Scan SNR Threshold MUST be larger than (>)Roaming SNR
Threshold
Max Scan Interval - Specify the maximum duration from 1s to 3600s
for channel scanning; 60s is default setting.
Min Scan Interval - Specify the minimum duration from 1s to 60s for
channel scanning; 10s is default setting
Scan SNR Fluctuation Threshold – Enter SNR from 0dB to 10dB; the
current AP's signal fluctuation (compared with previous scan result)
is higher than (>) this threshold, the station will do scanning. 5dB is
default setting.
Roaming Hysteresis – Select to enable that station will be stickier to
current associated AP.
Scan Channel List – Select the particular channel for scan
3. Click Submit
4. Click Save & Apply
Station Security Configuration
Figure 35 – Security Settings of Station