Owner's Manual
Table Of Contents
- Installation Manual
- Introduction
- Note
- To Ensure Safe Use, Always Follow These Precautions
- Tools Possibly Required (This Will Vary Depending On The Vehicle)
- Accessory List
- Factory Unit Disassembly Process (2007-2010 Only)
- Factory Unit Disassembly Process (2011-2018 Only)
- Glove Box Removal
- Removing B-Pillar Panel
- Removing Rear Right Side Panel
- Spare Tire and Wheel Removal
- Camera & Light Extension Cable Installation
- Bracket Installation
- Wiring Diagram: OEM Head Unit With SGS-CH01 (Sold Seperately)
- Wiring Diagram: OEM Head Unit With ALP-HRN-CAMCH (Sold Seperately)
- Wiring Diagram: Alpine Head Unit Using Direct Connection
- Wiring Diagram: Alpine Head Unit With SGS-CH01 (Sold Separately)
- Wiring Diagram: OEM Head Unit With SGS-CH01 & KCX-C2600B (Sold Separately)
- Wiring Diagram: OEM Head Unit With ALP-HRN-CAMCH & KCX-C2600B (Sold Separately)
- Troubleshooting
- Quick Installation Manual
Jeep Wrangler
HCE-RCAM-WRA 10/16
Wiring Diagram: OEM Head Unit With SGS-CH01 (Sold Seperately)
To Factory Main
Harness Connector
To Factory Harness
To SGS-CH01
Main Connector
IN OUT
SGS-CH01
(Sold Seperately)
Factory Head Unit
To Factory
Camera Connector
To Rear
Camera Input
CAM TRIG
To optional switch
(sold separately)
This will activate the camera
while the vehicle is not in reverse
with a +12V input. The illustration is
a standard rocker style switch
that should be able to be purchased
at most electronic supply stores.
Guidelines are not displayed when
manually triggered.
+12V
HCE-RCAM-WRA
Camera Extension Cable
Ground And
Accessory Can
Be Used To Power
Aftermarket Camera.
Refer to the SGS-CH01
manual for wire colors
and pins of rear camera
harness. Please note to
leave enough space in
case the connector
would need to be
soldered back on.
Power & Video
Unit
Accessory (Red)
Ground (Black)
To Chassis Ground
To Red Pin 4