Owner's Manual
Table Of Contents
- Owner's Manual
- Operating Instructions
- 1. Product overview
- 2. Installing the product
- 3. Using recording features
- 4. Operating on the Alpine navigation/display audio system
- 5. Settings
- 6. Using the mobile viewer
- 7. Using the PC viewer
- 8. Upgrading the firmware
- 9. Troubleshooting
- 10. Specifications
- Quick Reference Guide
- WiFi Network Information
- Warranty
24
4. Operating on the Alpine navigation/display
audio system
4.1 Screen layout
The following is an explanation of the Live view and Home screen layout.
For safety reasons, the screen is not displayed while the vehicle is moving.
• The features that are linked with the Navigation/Display Audio system are supported by the Product the
were produced in 2020 or later(Please confirm the Alpine website.)
• Depending on when the product model was shipped, program updates may be required.
4.1.1 Live view screen
On the Live view screen, you can view the currently recorded videos and operate the product by tapping on
the Alpine navigation/display audio system display. The Live view screen is displayed when you turn on the
ACC and start the engine.
Displays the video that the
rear camera is recording.
Tap the screen to display
full screen.
Displays the video that the
front camera is recording.
Tap the screen to hide or
displaytheMenubuttons.
Displays the current date and time.
Start manual recording.
MovetotheHomescreen.
Displays the current
vehicle speed.
Displays the current battery voltage.
Displays the current recording status.Displays the GPS icon.
Wait until the product is completely booted up after turning it on, and then begin operating the vehicle. The
video recording does not begin until the product is completely turned on (booted up).