Operating instructions

Alpine Supply Company 42 Direct Vent Gas Fireplace

LOG INSTALLATION

NOTE: Proper log installation is very important.

Read the instructions below carefully and refer to the

diagrams. If the logs are broken do not use the

fireplace until they are replaced. See the replacement

parts list in this manual to order the proper

replacement logs.

The logs are fragile and must be

handled with care. DO NOT FORCE THE LOGS

INTO POSITION.

Fig. 26– Rear Log Placement

4. Place the left hand side twig, with the split face

forward, onto the pin and then push back until it hits

the Rear stop. ( See Figure 29 )

Fig. 29–Rear & Right & Left Twig

Fig. 30– Front Twig

3. Place the right hand side twig, with the split face

Rearward, onto the pin and then push back until it hits the

The rear stop. ( See Figure 28 )

Fig. 27– Rear & Right Twig

5. Place the small twig in front of the left hand side twig,

its notch straddling the second from the left andiron and

pushed fully forward. The logs must be positioned prop-

erly to create the proper burning pattern. ( See Figure 30 )

Fig. 28–Rear & Right & Left Twig

1. Place the larger log on the grate centered and against

The wall. ( See figure 26 )

2. Place dime sized pieces of ember material around

Center burner ports. Use caution not to cover burner

Ports.