Product Manual

Confirm that the electricity at the main panel is switched to off before installing or
maintaining the unit.
The unit must be protected by an independent circuit.
Hardwiring
Live/Hot wire
brown, or red
Neutral wire
black, blue, white, or gray
Ground wire
green, or yellow
INTALLING THE HAND DRYER UNIT
CAUTION: Make sure that no electrical wiring or pipe work are located directly behind
area of drilling.
Be sure there is no obstruction between floor and dryer. If mounted over counter top place
dryer no less than 16 inches above counter. Do not install dryer over wash basin.
1. If hardwired, disconnect power source of electricity previously bought to the hand
dryer location.
2. Mark wall at appropriate mounting height according to height guide below.
Recommended Height Guide
From floor to bottom of dryer
Men
45”- 114 cm
Women
43”- 109 cm
Teens
42”- 107 cm
Young Children
34”- 86 cm
Handicapped
38”- 97 cm
3. Hold the template (supplied) against bare wall. Make sure that the line of template
representing bottom of dryer is horizontal. Mark location of screws.
4. Remove shipping security screw located at center top of back-plate.
5. Use wretch (supplied) to remove the two mounting screws located at the side of the
cover and lift cover up from base plate.
6. If electrical wiring entry is made from rear, remove the pre-formed knock-out from
the base plate.
7. Attach base plate to the wall at the 4 previously marked points. Beware if you prefer
unit not to meet wall use rubber gaskets supplied.
8. Attach cover to the base plate. Push bottom in first.
9. Replace screws previously removed from cover using wrench.
10. Restore power and test for proper operation.