Manual

SYSTEM WIRING & INSTALLATION
IMPORTANT NOTE
The End-of-Line Resistor Jumper
The End-of-Line Resistor jumper is located on the
back side of the monitor(s), accessible through the
opening in the plastic housing.
If your installation has only a single monitor, the
black plastic end-of-line resistor jumper must remain
in place on the monitor. If your installation has mul-
tiple monitors, the black plastic end-of-line resistor
jumper must remain in place on the monitor which
is farthest from the outdoor remote(s) and must be
removed from the other monitor(s).
Page 3