User Manual

4
ALPHAGUARD 2000 Series Autodialer
4.0 SYSTEM PROGRAMMING
All programming of the entry system is accomplished through the use of the system keypad and the
display located on the control panel. Use the supplied Directory Worksheets to generate a record of the
building occupants, their suite telephone numbers, assigned dial codes and keyless entry codes. These
sheets will be required for programming and in the event that changes are to be made.
Complete the Programming Worksheet that has been provided and ensure that this and the directory
worksheets are given to building management when installation and programming is completed.
4.1 Program Mode Entry / Exit
Enter the three digit System Master Code (default is * 1 2 3) to commence a programming session. Use
the '1' key on the keypad to scroll up the programming menu or the '3' key to scroll down to the necessary
function. When the necessary function is displayed on the screen, press the '#' key to select. Follow the
displayed instructions to make the necessary changes. When programming is complete, exit program
mode by pressing the '*' key twice.
4.2 Tenant Codes Entry / Review / Delete
Tenant Code Entry
Press '#' key to select this function when the program menu displays "TO PROGRAM CODES, PRESS
#". This function allows the entry of the tenant codes and telephone numbers. Enter the four digit tenant
code followed by the tenant telephone number (7, 10 or 11 digit telephone numbers can be
accommodated, see section 4.5). Press the '#' key to store the numbers. Continue in this fashion until all
codes and telephone numbers are stored. If the tenant codes are less than four digits in length, enter
zeroes as leading digits in the code , they will be ignored by the system during actual use but are required
for programming. If an error is made while entering a code or a telephone number, press the '*' key to
backspace.
Press the '*' key when finished to exit this mode and return to the programming menu.
Press the '*' key to exit the program mode if desired.