Installation Guide

Step1: Drill Holes in Wall for screws or screw anchors and attached Mounting Bracket to Wall
Determine your desired location for installation and make a mark for the location of the mounting bracket. Remove mounting
Bracket from backplate by loosening set screw in backplate as pictured below. Place center hole of mounting bracket over mark
made above. Make 8 marks where mounting screws will be placed as shown below. Drill hole at each of the marks. (You may
substitute other style mounting anchors or screws if desired). Place anchors into the holes made. Slip backplate and post onto
mounting bracket. After straightening the post into position, tighten the set screw to secure.
No portion of this document or any artwork contained herein should reproduced in any way without the written consent of ALLIED BRASS INC.
INSTALLATION INSTRUCTIONS
CL-28
20.10 mm / 0.79 in
Mounting Bracket
DRILLED HOLE
ANCHOR
MOUNTING BRACKET
SCREW
BACKPLATE
SET SCREW