Installation Guide

DRILLED HOLE

DETAIL M

ANCHOR

MOUNTING PLATE

SCREW

SET SCREW

Step 1:

Determine your desired location for installation and make a mark for the location of the mounting plate. Remove mounting

plate from backplate by loosening set screw in backplate as pictured below. Place center hole of mounting plate over mark

made above. Make 2 marks where mounting screws will be placed as shown below. Drill hole at each of the marks. (You may

substitute other style mounting anchors or screws if desired). Place anchors into the holes made. Place mounting plate over

holes and secure to mounting surface using screws as shown below.

Drill holes in Wall for screw anchors and attach Mounting Plate to Wall

PERSPECTIVE

DRILLED HOLE

AP-1-16-IRW

INSTALLATION INSTRUCTIONS

No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.

PAGE 1
AP-1-16-IRW INSTALLATION INSTRUCTIONS Step 1: Drill holes in Wall for screw anchors and attach Mounting Plate to Wall Determine your desired location for installation and make a mark for the location of the mounting plate. Remove mounting plate from backplate by loosening set screw in backplate as pictured below. Place center hole of mounting plate over mark made above. Make 2 marks where mounting screws will be placed as shown below. Drill hole at each of the marks.
PAGE 2
AP-1-16-IRW INSTALLATION INSTRUCTIONS Step 2: Attach Bracket to Mounting Plate. Place bracket on mounting plate and secure by tightening set screw as shown below. N PERSPECTIVE MOUNTING PLATE BACK PLATE SET SCREW DETAIL N No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.