APC4017 TM Owner’s Manual 20 Gallon Vertical AIR COMPRESSOR Please read and save these instructions. HAVE QUESTIONS OR NEED SERVICE DO NOT RETURN TO STORE! 888-896-6881 www.allpoweramerica.
SPECIFICATIONS TABLE Maximum Air Pressure Air Tank Capacity Air Flow Capacity Motor Required Circuit Pump Stage Air Outlet Size Accessories 115 PSI 20 Gallons 6.2 CFM at 90 PSI 5.2 CFM at 40 PSI 2.5 HP Working / 4 HP Peak 120 Volt / 60 Hz / 12 A / 1-Phase Minimum 20 Amp *Dedicated Single 1/4” - 18 NPT Air Intake Filter; Air Hose Coupler #233060 *A dedicated circuit is used only for a single load, for this compressor.
7. DO NOT OVERREACH. Keep proper footing and balance at all times to prevent tripping, falling, back injury, etcetera. 8. INDUSTRIAL APPLICATIONS MUST FOLLOW OSHA REQUIREMENTS. 9. STAY ALERT. Watch what you are doing at all times. Use common sense. Do not use this product when you are tired or distracted from the job at hand. 10. CHECK FOR DAMAGED PARTS. Before using this product, carefully check that it will operate properly and perform its intended function.
SPECIFIC PRODUCT WARNINGS AND PRECAUTIONS 1. WARNING: Make sure to fill the Air Compressor with a premium quality, 30-weight, non-detergent compressor oil before each use. Running the Air Compressor with no oil or low oil will cause damage to the equipment. Note: The oil reservoir has an optimal capacity of 30 ounces of oil. 2. WHEN CHECKING THE OIL LEVEL: Make sure to unscrew (do not pull) the Breather Valve (14B) out. (See Figure C, and Assy. Diagram B.) 3.
TO EXTEND THE LIFE OF YOUR AIR TOOLS AND EQUIPMENT, it is recommended to install an oiler and water filter in series with the Air Output Line of the Air Compressor. UNPACKING When unpacking, check to make sure all the parts shown on the Parts Lists on pages 9, and 10 are included. If any parts are missing or broken, please call our service department Toll Free 888-896-6881 as soon as possible. IMPORTANT! This compressor is shipped with the oil fill plug removed and without oil.
2. If necessary, add a premium quality, 30-weight, non-detergent compressor oil into the Oil Fill Hole until the level of oil reaches the maximum level as indicated on the Oil Window (20B). The optimal capacity of the oil reservoir is 30 ounces. Do not overfill. Then thread the Breather Valve back into the Oil Fill Hole, being careful not to strip the plastic threads. (See Figure C, and Assy. Diagram B.) Breather Valve (14B) Front Cover (18B) Oil Window (20B) FIGURE C To Turn The Air Compressor On: 1.
8. NOTE: With the Air Compressor turned on, the operation is automatic and under the control of the automatic switches inside the box under the Power Switch (1A). NEVER open the power switch box or adjust the controls within. To Adjust The Air Output To The Pneumatic Tool: 1. NOTE: When adjusting the air pressure being forwarded to the pneumatic tool, you will need to compare the pressure readings of both the Tank Pressure Gauge (3A) and the Tool Pressure Gauge (4A).
Reference: Overload Switch (35B) The overload breaker will trip if an over-current condition is sensed, stopping the motor. If this occurs, shut off the pressure switch and wait at least 5 minutes. Release the air pressure in the tank to ease restarting. Then press the breaker button to reset it, and turn on the pressure switch. INSPECTION, MAINTENANCE, AND CLEANING 1.
PARTS LIST A / ASSEMBLY DIAGRAM A Part 1A 2A 3A 4A 5A 6A 7A 8A 9A 10A Description ON/OFF Power Switch Tool Pressure Adjuster Tank Pressure Gauge Tool Pressure Gauge Pressure Release Valve Air Flow Valve Air Filter Air Flow Lid Air Tank Water Drain Valve Qty. 1 1 1 1 1 1 1 1 1 1 16A Part 11A 12A 13A 14A 15A 16A 17A 18A 19A 20A Description Quick Release Coupler Rubber Wheel with Bolt Washer Nut Fitting Oil Drain Plug with Gasket Foot Unloader Valve Polyurethane Unloader Tube Copper Air Tube Qty.
PARTS LIST B / ASSEMBLY DIAGRAM B Part 1B Description Bolt Qty. 4 Part 19B Gasket Description Qty.
LIMITED WARRANTY All-Power warrants to the original purchaser who uses the product in a consumer application (personal, residential or household usage) that all products covered under this warranty are free from defects in material and workmanship for one year from the date of purchase. All products covered by this limited warranty which are used in commercial applications (i.e. income producing) are warranted to be free of defects in material and workmanship for 90 days from the date of original purchase.
LIMITED WARRANTY (cont’d) THIS WARRANTY DOES NOT COVER: Merchandise sold as reconditioned, used as rental equipment, or floor or display models.
