User Manual

24
Set mode
3. Pressing any key other than the dial knob
or the UP/DOWN keys will complete the
setting and the unit will exit the parameter
setting mode.
IMPORTANT
Pressing PTT switch will not exit the set mode setting.
0HQX6FDQW\SHVHOHFWLRQ
This is to select the scan resume condition. The BUSY setting resumes scanning when
received signal is gone and TIME setting allows the radio to resume scanning after 5, 10,
20,30 or 60 seconds. This parameter can be selected for both left and right sides in VFO
mode and cannot be selected for each band.
1. Press and hold FUNC key to enter the
parameter set mode. Press dial to select
menu 04. Factory default setting is
[BUSY].
2. By rotating the dial, the display changes
as shown and the scan type will be
changed.
3. Select a desired item.
4. Pressing any key other than the dial knob
or the UP/DOWN keys will complete the
setting and the unit will exit the parameter
setting mode.
BUSY TIME05 TIME10 TIME20 TIME30 TIME60
(seconds)
0HQX0HPRU\VFDQPRGHVHOHFWLRQ
Use this function to select memory scan conditions. (P.59)
This parameter can be selected for both left and right sides in VFO mode and cannot be
selected for each band.
1. Press and hold FUNC key to enter the
parameter set mode. Press dial to select
menu 05. Factory default setting is
[SKIP].
ALLSKIP FAV