User Manual

23
Set mode
6HWPRGHPHQX
0HQX&KDQQHO6WHSVVHWWLQJ
This is to select the channel step to be used in the VFO mode. Refer to the P.21for the
sequence of the actual steps and how they are displayed.
0HQX2SHUDWLQJPRGHVHOHFWLRQ
Operating modes are determined by the modulation of the radio signals. The transceiver has
total 5 operating modes (AUTO, FM, NFM, AM, NAM modes). The mode selection is stored
independently for each band and memory channel. Typically, AM mode is used for the air
band (118–136.995 MHz), and receive is only available.
1. Press and hold FUNC key to enter the
parameter set mode. Press dial to select
menu 02. Factory default setting is
[Auto].
2. Rotate the dial to select FM, NFM, AM or
NAM. When NFM or NAM selected Nar will
appear on the display.
3. Pressing any key other than the dial knob
or the UP/DOWN keys will complete the
setting and the unit will exit the parameter
setting mode.
0HQX0LFURSKRQHJDLQ$GMXVWLQJ
1. Press and hold FUNC key to enter the
parameter set mode. Press dial to select
menu 03.
Factory default setting is [0dB]. This
setting is individual regardless of the
band or VFO.
2. Rotate the right dial to select a value
between -23dB to +23dB.
Selecting (-) will decrease and (+) will
increase microphone’s gain. Also
microphone gain can be adjusted during
transmission.
NAMAMNFMFMAUTO