User Manual

19
Basic Operations
5HYHUVH)XQFWLRQ
This function is for monitoring the transmission
frequency instead of reception frequency in repeater
operation. This technique is commonly used to check if
it is possible to communicate without using repeater by
monitoring the accessing station’s signal strength.
1. Set SHIFT first. Press FUNC key then
press MW key while [FUNC] appears on
display.
[ ] icon illuminates on the display to indicate that the
reverse function is activated and the squelch opens.
2. Pressing any key on the front panel will
cancel the operation.
IMPORTANT
The Reverse function only operates on the MAIN band.
Without SHIFT setting Monitor function will operate instead of Reverse
function.
NOTE
Rotate squelch knob to monitor repeater’s down link.
7R7UDQVPLW
1. Set the transmission band to the MAIN
side.
2. Be sure that you are authorized to
operate on the selected frequency. Check
the system and monitor the frequency to
make sure that you are not going to
disturb any ongoing communications.
3. Press the PTT key on the microphone.
The TX lamp (red) illuminates to show the unit is
transmitting.
4. Speak into the microphone in a normal
tone while keeping the PTT key pressed.
Hold the microphone approximately 5cm away from
your mouth. Speaking too close or too loud may result
in poor transmitted audio. Adjust microphone gain in set
mode (Menu 03)
Auto repeater setting
TX lamp