User's Manual
Table Of Contents
- Before operating the transceiver
- Attention
- _
- New and Innovative Features
- Standard Accessories
- _
- For a base station set up
- For a mobile station set up
- Location
- _
- Installing a Mobile Antenna
- Installing the Transceiver
- Front Panel
- External power control function
- Power supply voltage display function
- Part Names and Functions
- Front Panel
- Rear Panel
- Display
- Microphone EMS-53 (Standard)
- _
- Turning the unit on and off
- Switching the MAIN band
- Audio Volume level setting
- Changing frequency by channel step
- Changing frequency by 1 MHz step
- Setting the channel step
- Shift Direction and Offset frequency setting
- Memory Mode
- Recalling a memory channel
- Memory channel deleting
- Programmable data in the memory channel
- Channel name (Alphanumeric) registration function
- CALL mode
- To recall a CALL channel
- To receive signals
- Monitor function
- Reverse function
- To transmit
- Selecting transmission power
31
Parameter Setting Mode
Bell
The bell informs you that you are being called by sounding a bell, and flashing the bell icon on the
display.
Busy-Channel-Lock-Out (BCLO)
This function prohibits transmission as long as there is a signal on the receiving frequency.
The default is BCLO-OFF, which is the off position. By activating this function, the radio transmits
only when:
1.No signal is received (BUSY icon is gone) on the receiving frequency.
2.The tone-squelch is not opened by receiving the corresponding CTCSS tone.
3.As above, with DCS code.
Otherwise a beep sounds but the unit does not transmit even when the PTT is pressed.
1. [BELL OFF] icon appears on the display.
2.
By rotating the main dial, the display changes as
shown and the Bell function setting is changed.
BELL OFF BELL ON
1. The [BCLO OFF] icon appears on the display.
2. By rotating the main dial, the display changes
as shown and BCLO setting is changed.
Theft Alarm
(Please refer page 45 for details)
BCLO OFF BCLO ON
1. The [SCR OFF] icon appears on the display.
2. By rotating the main dial, the display changes
as shown and Theft Alarm is set ON/OFF.
3. When Theft Alarm is set, [*] icon appears on
the display.
SCR OFF SCR ON
SCR DLY
(Refer page 27 for how to enter the setting mode.)