User's Manual

Set Mode Configurations

2. Rotate the dial to change the display as shown below

and select the antenna.

When using the earphone antenna, a signal may be

unstable depending on the conditions, such as position

of the earphone cord and receiving frequency.

(3)AM Bar-antenna setting

You can choose whether or not to use the AM bar-antenna.

When you set this function to ON, it comes to receive 100kHz to

3MHz frequencies including AM radio. When you set it to OFF,

the DJ-X7 uses the antenna installed to the DJ-X7's antenna

connector.

1. Select the set menu No.3 by pressing the dial.

The following is displayed on the LCD.

2. Rotate the dial to switch ON/OFF of the function.

(4)Shortwave Bar-antenna setting

You can choose whether or not to use the shortwave bar-

antenna. When you set this function to ON, it comes to receive

3MHz to 30MHz frequencies including shortwave bands. When

you set it to OFF, the DJ-X7 uses the antenna installed to the

DJ-X7's antenna connector.

1. Select the set menu No.4 by pressing the dial.

The following is displayed on the LCD.

2. Rotate the dial to switch ON/OFF of the function.

(5)Illumination Lamp function setting

As the factory default setting, any key operations automatically

turn on the backlight of the LCD and turn it off when no

operation continues for 5 seconds. When you set this function

to ON, it becomes always ON state. Setting it to OFF

deactivates the backlight feature.

1. Select the set menu No.5 by pressing the dial.

The following is displayed on the LCD.

Memo

「SmA」「EAr」