Instruction Manual

Horizontal Slide Kit Installation Instructions

PARTS INCLUDED: TOOLS NEEDED:

Mounting Brackets

Trucks

Track

End-Stops

Marker to Mark Holes

Drill

Screwdriver

Step Stool or Ladder

Tape Measure

STEP 1

Mount brackets at desired height

above opening using appropriate

fasteners supplied by others. Make

sure brackets are mounted level and

equally spaced.

STEP 2

Insert track into brackets.

NOTE: Depending on location, track

may need to be inserted into brackets

before brackets are mounted.

STEP 3

Tighten set screws on brackets. Then,

insert one end-stop in one end of the

track and slide the appropriate amount

of trucks into the other end of the

track.

STEP 4

Once the trucks have been installed,

insert an end-stop in the end of the

track. To mount the angled hardware,

the existing holes on the top of the

bracket will need be drilled out with a

1/2” drill bit. Then the angled hardware

can be mounted to the threaded rods

that are attached to each truck. Attach

the angled hardware as shown in the

illustration to the right.

FOR ANY QUESTIONS OR COMMENTS, PLEASE CONTACT AN ALECO REPRESENTATIVE

2720 E. Avalon Ave. Muscle Shoals AL, 35661 Phone (256) 248-2402 or toll free 1-800-633-3120

Fax: 1-800-750-9616 email: info@aleco.com web: www.aleco.com

PAGE 1
Horizontal Slide Kit PARTS INCLUDED: Installation Instructions Mounting Brackets Trucks Track End-Stops TOOLS NEEDED: Marker to Mark Holes Drill Screwdriver Step Stool or Ladder Tape Measure STEP 1 Mount brackets at desired height above opening using appropriate fasteners supplied by others. Make sure brackets are mounted level and equally spaced. STEP 2 Insert track into brackets. NOTE: Depending on location, track may need to be inserted into brackets before brackets are mounted.
PAGE 2
Horizontal Slide Kit Installation Instructions STEP 5 Mount supplied PVC strips to angled hardware using desired overlap. Make sure when installing strips that the strips are mounted with concave sides facing each other as shown in the illustration below. TOP VIEW OF STRIPS STEP 6 Once all strips are installed, they can be trimmed using a common utility knife to leave approximately 1/4” clearance from the floor.