Assembly Instructions

Additional Tools Required: Allen Wrench
ASSEMBLY INSTRUCITIONS
1. Open box and remove all parts from inside. Un-package all
components.
2. Using the diagram included, identify all parts.
3. Sort and pair all bolts, locking washers, washers and screws. Pair all
bolts with locking washers and washers using the diagram, the locking
washer always goes on the bolt first.
4. Lay chair back assembly on a clean protected surface, face side up.
5. Unzip the zipper on the bottom of the seat. Attach the seat assembly
to the back assembly by aligning holes on seat and back. The holes
should align. Using parts C, F and E insert bolt with washers in the
center hole, hand tighten.
6. Using parts A,F and E insert bolts into the left and right corner blocks
on each side of the back of the seat assembly, hand tighten. (bolts
should tighten easily, if needed adjust the angle of the seat to help
with clearance.)
7. Attach front leg by inserting parts B,F and E through the front corner
blocks of the seat assembly. Hand tighten only.
8. Identify left and right arms. Attach by aligning hole on the bottom of
the seat assembly by using parts D,H and G insert parts, and tighten
only. From the back side of the back assembly open Velcro closure
by pulling gently upward for either corner, attach arms to the back
using parts D and H. Set chair upright.
9. Tighten all bolts ¼ turn beyond hand tightened using the tools
provided. Align and reattach fabric to the back using the Velcro
closure. Zip bottom closed. Your chair is now complete – Enjoy!!
*** Helpful hint *** Store Allen wrenches in back assembly secured by the
Velcro closure to have for future use.