User Guide

Quick Start Guide 5
AOS-W 3.1
AOS-W 3.1 Quick Start Guide
You should see a screen similar to the following:
FIGURE 1 Initial Setup for Web Browser Connection
5. Enter the information described in Table 1.
6. Click Save & Reboot when you are done.
The WLAN Switch reboots.
Proceed to “Connect the Switch to the Wired Network” on page 6.
Serial Port Connection
The serial port is located on the front panel of the WLAN Switch. When you
connect a terminal or PC/workstation running a terminal emulation program to
the serial port on the WLAN Switch, you can run the Initial Setup.
To run the Initial Setup from a serial connection:
1. Configure your terminal or terminal emulation program to use the following
communication settings:
2. Connect your terminal or PC/workstation to the serial port on the WLAN
Switch using an RS-232 serial cable.
All accessory kits shipped with Alcatel WLAN Switches contain an RJ-45
cable and DB-9 to RJ-45 adapter for this purpose. You may need to provide a
USB adapter to connect the serial cable to your PC.
3. Boot up the Alcatel WLAN Switch.
Baud Rate Data Bits Parity Stop Bits Flow Control
9600 8 None 1 None