User's Manual

3/16/04 Preparing a Version 2.0 OmniAccess AP or OmniAccess AP 1200R
90-100832-000 Rev 5Alcatel OmniAccess Wireless Access Point Quick Installation Guide 8
Configuration SetupConfiguration Setup
Does My AP Qualify for this Procedure?Doe s My AP Qualify for this Proced ure?
• If your 2.0 or later version later OmniAccess AP(s) or OmniAccess AP 1200R(s) cannot be
configured for any reason using the following procedure, refer to RMA Procedures in the Alcatel
OmniAccess Wireless Product Guide.
Configuration Steps for an OmniAccess AP or OmniAccess AP 1200RConfiguration Steps for an OmniAccess AP or OmniA ccess AP 1200R
1. Configure the Alcatel OmniAccess Switch or Appliance in LWAPP Layer 3 Mode and make sure
its DS Port is connected to the network. Use CLI, Web Browser and/or ACS procedures as
described in the Alcatel OmniAccess Switch and Appliance Quick Installation Guide and the
Alcatel OmniAccess Wireless Product Guide.
Note: When you are installing a OmniAccess AP 1200R or an OmniAccess AP, a DHCP server
must be accessible by the OmniAccess AP 1200R or an OmniAccess AP.
- Make sure AP ports are available (either Direct-Connect Mode through the Switch
physical ports, or in Appliance Mode through the Alcatel OmniAccess Switch or
Appliance Management/AP-Manager Interface).
- Set the Alcatel OmniAccess Switch or Appliance as the Master, so new OmniAccess APs
always associate with it.
- Refer to the Alcatel OmniAccess Wireless Product Guide for other settings.
2. Take the AP or OmniAccess AP 1200R out of the box and plug it into the front panel of the
Master Switch (Direct-Connect Mode
), or through the same subnet that Alcatel OmniAccess
Switch or Appliance is on (Appliance Mode
).
3. Apply power to the AP:
- Use 802.3af-compliant Power Over Ethernet (PoE) from the Alcatel OmniAccess Switch
or Appliance or from an orderable inline power injector. If you do not have PoE
available, use an orderable external AC-to-48 VDC Power Supply plugged into the side
of the AP.
- After powering up the AP, the RED Alarm LED comes on for a short period (about 15-20
seconds) and then all the LEDs blink sequentially back and forth, indicating that the AP
is trying to find an Alcatel OmniAccess Switch or Appliance to connect to. This can
continue for up to five minutes. If the AP remains in this mode for more than five
minutes, the AP is unable to find the Master Alcatel OmniAccess Switch or Appliance.
Check the connection between the AP and the Alcatel OmniAccess Switch or Appliance
and make sure the AP and the Alcatel OmniAccess Switch or Appliance are on the same
subnet.