ELECTRONIC TROUBLE SOLUTION Locks works in reverse. Reverse motor wires in connector. Lock will not accept new codes during programming. Disconnect battery connector, hold down any button until lock resets, then reconnect and start programming again. Lock drains batteries quickly. Lock is inoperative. Check all wires for pinching or cutting. Check for water damage. If condition persists, consult factory. Check batteries for proper polarity and check for cut wires.
ey AK own INSTALLATION : INSTRUCTIONS INSIDE MOUNTING PLATE MOTOR PLASTIC WIRE Aplenty OUTSIDE BEHIND OUTSIDE HOUSING ROSE PLATE — un LEVELER Ne. CATCH PY QUAYSIDE SPINDLE WIDE MOUNTING SCREWS 7 CYLINDER RETAINER SIDE ROSE PLATE DUST BOX ’ .
¢ HORIZONTAL OF oa o00R es oF LEVER MARK. {44mm} HEIGHT OR VERTICAL LINE (35mm) DOOR « THICKNESS oF LOCK FiG. 1 DOOR PREPARATION: 1. Fld and place template on high edge of door at the recommended height from floor. 2. Mark hole centers on door and road edge. 3. Drift 3/8" Thru-Bolt holes first, then drill hole. FOR HARDWOOD DOORS: Etch on both sides of hole to accommodate mounting plate tabs. FOR HOLLOW METAL DOORS require horizontal and vertical lack and latch case support.
LATCH YOKE O DETRACTOR re] LATCH PLASTIC SPACERS I= Py OUTSIDE MOURNING ROSE PLATE QO = L LOCKS COME REASSEMBLED FOR RIGHT HAND (RIGHT HAND REVERSE). INSIDE OUTSIDE JE 0 FIG. 9a TO REVERSE HANDING-KNOBS: with the inside Knob and Housing off. 1. Insert key into outside cylinder & turn clockwise 45°, depress LOCK BODY ©) TAL HOUSING FIG. VIEW FROM INSIDE OF DOOR: 1. Latch Yoke must engage lock housing and tailpiece must engage Detractor. FIG.
SIDE SCREWS CONNECTOR WIRES HOUSING INSIDE MOUNTING PLATE #6. fia So FIG. 11 INSTALLING INSIDE TRIM: (Housing & leverage) 1. Connect the Battery and Motor connectors. Note the connectors fit only one way (do not force them). See inset. Seal the connectors with Dielectric Grease included. 2. Place battery pack & loose wires inside housing 3. Place battery pack cover on and fasten w/screw. FOR LEVERS: 4a. Place Inside lever on spindle and push unit it engages with Lever Catch.
TAILPIECES Cha, D REPLACEMENT TAILPIECE FOR LORI AND ILS #620 Washer TESTATES STANDARD ALARM LOCK TAILPIECE #HERESY Washer $WA150 REPLACEMENT TAILPIECE FOR SCHLEP #HOSED IC CORE FOR USE WITH BEST, ARROW, FALCON, MEDICARE, KSP #HWE598 Washer #$WAT60 FIG, 18, TO INSTALL INTERCHANGEABLE CORE 1. Insert control key in core and tum clockwise, 2. Insert tailpiece in core. 3. With control key in core, insert core fully into Jock. 4. Turn key counterclockwise and remove key. TQ REMOVE (C CORE-ALL FUNCTIONS: 1.