User's Manual

LED will return to the color representing
what the current programming mode is. At
this point, you can once again press and
release the trigger to toggle between Dwell,
Debounce, and Eye Mode programming
modes.
You can perform a complete reset of the
Dwell, Debounce, and Eye Mode to the
factory defaults when you are in the
program starting point (where you can
toggle the programming mode).
To do this, just hold down the trigger for 5
full seconds. It does not matter what
programming mode you are currently in
(Dwell, Debounce, or Eye Mode). The
LED will start flashing red, letting you
know that a reset operation is being
performed. After this occurs, you will be
back to the programming starting point.