Operation Manual

The unit can be turned on at a specified time every day with the built-in timer.
Preparation
Make sure the clock is set correctly.
Use the remote control.
1 Press the TIMER button while pressing the SHIFT button once to display , and press the SET button
within 4 seconds.
is displayed, and the hour flashes.
NOTE
If you press the SET button after 4 seconds, another operation may start.
2 Designate the hour of the timer-on time by pressing the DOWN or UP button, and the SET
button. Repeat to designate the minute of the timer-on time.
After you designate the timer-on time, one of the source name flashes on the display for 4 seconds.
3 Within 4 seconds, press the FUNCTION button to select a source.
The selected source name flashes for 4 seconds. At this time, the selected function button does not light up.
• If this step is not completed within 4 seconds, repeat from step 1.
• If the TUNER button is pressed, the band cannot be selected in this step.
CLOCK AND TIMER (cont.) pg. 20
4 Within 4 seconds, select the duration for the timer-activated period with the DOWN or UP
button.
The duration for the timer-activated period can be set between 5 and 240 minutes in 5-minute steps.
• If this step is not completed within 4 seconds, repeat from step 1.
5 Prepare the source.
To listen to a CD, load the disc to be played first on try 1.
To listen to a tape, insert the tape into deck 1 or 2.
To listen to the radio, tune in to a station,
6 Press the POWER button to turn the unit off after adjusting the volume and tone.
remains on the display after the power is turned off (timer standby mode.)
When the timer-on time is reached, the unit turns on and begins play with the selected source.
• The volume level is automatically set to 16 when the power is turned off with the volume level set to 17 or more.