Installation Manual

LoadLifter 5000 Series

MN-1048

5. On the front of the driver’s side spring perch there is a hole and a slot (Fig. 8). In order

to mount the lower bracket, it will be necessary to tap the hole using the 5/16” self-

tapping screw (M) by starting the bolt making sure it is perpendicular to the perch.

Use a ratchet and socket to drive the bolt in, creating the threads in the spring perch

(Fig. 9). Remove the bolt for later use.

If this truck does not have an emergency brake cable bracket and mounting bolt on the

right (passenger’s) side as noted (has an open hole as noted on driver’s side) Follow step

5 for this side by self-tapping the hole.

6. Set the lower bracket (F1 or F2) on the axle, making sure the tabs wrap around the

spring perch (Fig. 10). Repeat for the other side.

It will be necessary to

tap the round hole in

the forward driver’s

side spring perch. If

there is no emergency

brake cable bracket

and mounting bolt as

specified in Fig. 7 on the

passenger’s side, repeat

and tap the round hole as

instructed.

Note:

Four-wheel

drive

installation

shown.

g. 8

g. 9

g. 10

NOTE