Installation Manual

LoadLifter 5000 Series
MN-1048
14
Installing the Air Lines
Air lines are routed from the air springs to Schrader valves. LoadLifter 5000 series air
lines come in two styles: nylon and braided stainless steel. Begin by choosing locations
for the Schrader valves and drill a 5/16” (8mm) hole, if necessary (Fig. 34).
KEEP AT LEAST 6” (150MM) OF CLEARANCE BETWEEN ALL AIR LINES AND THE
EXHAUST SYSTEM. AVOID SHARP BENDS AND EDGES.
INSTALLING NYLON AIR LINES
1. Cut the air line in half. Make clean, square cuts with a razor blade or hose cutter
(Fig. 35). Do not use scissors or wire cutters.
2. Use zip ties to secure the air line to fixed points along the chassis. Do not pinch or kink
the air line. The minimum bend radius for the air line is 1 ” (25mm) . Leave at least 2”
(50mm)of slack in the air line to allow for any movement that might pull on the air line.
3. Install the Schrader valve in the chosen location (Fig. 36).
Good cut Bad cut
A. Inside fuel tank filler door C. License plate or
B. Inside rear wheel wells rear bumper area
MICHIGAN
XXX-XXX
www.MICHIGAN.gov
A. B. C.
MICHIGAN
XXX-XXX
www.MICHIGAN.gov
If a location for the Schrader valve other than the back of
the vehicle is chosen, it may be necessary to coil the
excess air line. The braided stainless steel air line cannot
be trimmed.
A. Inside fuel
tank filler
door
B. Inside rear
wheel wells
C. License
plate or rear
bumper area*
* For LoadLifter 5000 Ultimate Plus kits, the recommended location
for the Schrader valves is the rear bumper area or license plate.
MICHIGAN
XXX-XXX
www.MICHIGAN.gov
A.
B.
C.
USE IN
Standard,
Ultimate,
7500XL
USE IN
Plus
upgrade kit
USE IN
Plus combo
manuals
MICHIGAN
XXX-XXX
www.MICHIGAN.gov
If a location for the Schrader valve other than the back of the vehicle is
chosen, it may be necessary to coil the excess air line. The braided
stainless steel air line cannot be trimmed.
USE IN
Plus
upgrade kit
Hex nuts
Star washer
Rubber washer
Air Line Setup for Compressor Integration
Air Line Setup Without Compressor System
Vehicle body
or bumper
Hex nuts
Flat washer
Star washer
Rubber washer
Nylon air line
to compressor
system and
Schrader valve
Flat
Flat
Vehicle body
or bumper
Braided stainless steel
air line to air spring
5/16” (8mm)
hole
AN to PTC
fitting
Schrader
valve
Vehicle
body or
bumper
AN
Schrader
valve
Air line hex nut
Flat washer
Nylon air line
to air spring
5/16” (8mm) hole
Braided
stainless
steel air line
to air spring
Hex nuts
Flat washer
Star washer
Rubber washer
Schrader
valve
Vehicle
body or
bumper
Nylon air line
to air spring
5/16” (8mm) hole
g. 35
g. 36
g. 34
CAUTION