Instructions / Assembly

5
7. Atthistimetighten all boltsstartingwiththeboltsin
gure2,thentheboltsingure3.
8. Assembletheboommountbrackettotherearofthe
hitchtubesusingtwo5/16"x2"hexboltsand5/16"
nylocknuts.Seegure4.
9. Assembletheboombarstotheboommountbracket
usingtwo5/16"x1-1/4"carriagebolts,toothlockwashers
(betweenthebarandbracket),5/16"atwashersand
knobs.Theboomconnectinghoseshouldextendupward.
Seegure5.
NOTE: Make sure the nozzle openings face straight
downwhentheboombarsareinthehorizontaloperating
position.
FIGURE 6 VIEWED FROM REAR
FIGURE 5
FIGURE 4
10. Assemblethelargeandsmallspraygunclipstothe
sideofthetankusingtwo#10x1/2"screwsand#10
lockwashers.Seegure6.
5/16" NYLOCK NUT
BOOM MOUNT
BRACKET
5/16" x 2"
HEX BOLT
SPRAY GUN
CLIP (LARGE)
SPRAY GUN
CLIP (SMALL)
#10 x 1/2"
SCREW
#10 LOCK
WASHER
CARRIAGE BOLT
5/16" x 1-1/4"
KNOB
5/16" WASHER
WASHER
(TOOTH LOCK)
BOOM BAR
BOOM CONNECTING HOSE
ENGLISH