User Manual
Table Of Contents
- Table of contents
- About this manual
- Introducing the Drystar 5500
- Basic operation (operator mode)
- Advanced operation (Key-operator mode)
- Overview of Key-operator functions
- Stopping the printing process
- Viewing printer information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Performing the calibration procedures
- Installation
- Quality control for general radiography applications (DT 2 B & DT 2 C)
- Quality control for mammography application (DT 2 Mammo) (optional)
- Controlling the Drystar 5500 via a remote PC (with browser)
- System description
- Preventive maintenance and replacements
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Remarks for HF-emission and immunity
- Remarks for HF-emission and immunity
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in an electromagnetic environment in which the radiated high frequency disturbance variabl...
- Remarks for HF-emission and immunity
- Index
71
2900H EN 20071108 Advanced operation (Key-operator mode)
DRYSTAR 5500/5503 REFERENCE MANUAL
4 Press the Escape key to quit the Key-operator mode.
When the settings have been changed, the ‘accept modifications’ window is displayed:
Each time the settings have been changed and confirmed, an automatic back-up of the
new configuration is made on the hard disk. You will also be asked to create a back-up
floppy.
Select ‘yes’ if you wish to accept the changed settings. Press the Confirm key.
Select ‘no’ if you do not wish to accept the changed settings. Press the Confirm key.
You will return to the Main menu.
After selecting ’yes’, the ‘Update back-up’ screen is displayed:
If you want to save the configuration on the back-up floppy, select ‘yes’ and press the
Confirm key. The printer will now enter the ‘Saving the current configuration’ (refer to
page 105).
If you only want to save the configuration on the printer hard disk, select ‘no’ and
press the Confirm key.
Next, the following screen is displayed:
Press the Confirm key to reset. After the reset, the new settings will be active.
Press the Escape key to quit the application. The old settings will remain active until
the next reset.