Owners manual

9991-2 07-17 JEEP JK BUMPS (Rev B).docx
13. Remove upper lock ring from the bumpstop, slide it up from the bottom and re-install lock ring with the included
spanner so that it is tight in the existing hole.
**Check to see that both rings are fully engaged to the frame, if they do not sit correctly, remove the bumpstop and
use the grinder to remove any sections that are causing the lock rings to sit flush in the hole.
14. Re-install the coil springs, and shocks using the reverse process used above. Be sure to tighten all bolt to factory
torque specs.
15. Reinstall wheels and tighten lug nuts to factory spec.