User's Manual

This device is intended only for OEM Integrators. The OEM integrator should be
aware of the following important issues.
Labeling of the End Product
The end product integrate this module has to be clearly identified on the label that this
end product contain an FCC approved RF module. The format of such statement
could containTx FCC ID: L9N-7880
Integration Note
a) This module is authorized under limited module approval specified to mobile host
equipment. So, the antenna must be installed such that 20cm is maintained
between the antenna and users.
b) The transmitter module may not be co-located with any other transmitter or
antenna.
As long as the 2 conditions above are met, further transmitter testing will not be
required. However, the OEM integrator is still responsible for testing their
end-product for any additional compliance requirements required with this module
installed (for example, digital device emission, PC peripheral requirements, etc.)
IMPORTANT NOTE:
In the event that these conditions can not be met, then the FCC authorization is
no longer considered valid and the FCC ID can not be used on the final product
(including the transmitter) and obtaining a separate FCC authorization.