User's Manual

Deployment Guide 69
MOUNTING THE HIVEAP 320
Figure 4 Attaching the HiveAP 320 to the Mounting Plate
When done, adjust the ceiling tiles back into their former position.
Locking the HiveAP 320
To lock the HiveAP 320 to the mounting plate, use the security screw and bit that are included with the mounting
kit. You will also need a screw driver or an electric drill that will accept the bit.
1. Insert the security screw through the hole in the HiveAP 320 and begin to thread it into the hole in the mounting
plate (see Figure 5).
Figure 5 Locking the HiveAP 320 to the Mounting Plate
2. With the security screw bit in a screw driver or electric drill, tighten the screw into place, securing the HiveAP
to the mounting plate.
Push HiveAP
With the HiveAP 320 upside down, align the round tab and security screw
hole extnesion on the mounting plate with the keyhole opening and security
screw cavity on the HiveAP 320, and press the HiveAP upward.
4
5
Pushing from the LED end of the HiveAP, slide it toward the bottom
end of the plate until the two rippled tabs on the mounting plate
snap over the nubs on the undersdie of the HiveAP.
Security Screw
HiveAP 320
Mounting Plate
Ceiling Track Note: The ceiling tiles are removed for clarity.