User Manual

4. Water is detected by the Sensor’s probe 3 and 4
5. Water is detected by the Sensor’s probe 1,2,3 and 4
Next Section
[Heading 1]Advanced.[/Heading 1]
[Heading 2]Send a wake up notification.[/Heading 2]
In order to send your Sensor new configuration commands from your Z-Wave controller or
gateway, it will need to be woken up.
1. Pre
ss the Action Button on the Sensor unit and then release the Action Button. This will trigger
and send a wake up notification command to your controller/gateway.
2. If y
ou want your Sensor to keep awake for a longer time, press and hold the Action Button on
the back of the Sensor unit for 3 seconds, then your Sensor will wake up for 10 minutes and the
orange LED will fast blink while it is awake.
[Heading 2]Removing your Sensor from your Z-Wave network.[/Heading 2]
Your sensor can be removed from your Z-Wave network at any time. You'll need to use your
Z-Wave network's main controller/gateway. To do this, please refer to the part of their respective
manuals that tell you how to remove devices from your network.