Specifications

Page 6
Online Support at www.digisender.net
DG440 DigiSender™ X7
STEP 2
Install the DigiSender™ X7 Transmitter Unit
The transmitter unit is designed to send video and sound from one of up to 4
connected sources to a receiver somewhere else in your home.
What’s the A/B switch for??
STEP 1
STEP 2
STEP 3
Connect DigiConnector™ 1 into your satellite or
cable receiver. Use the SCART socket labelled ‘TV’
and connect any existing SCART lead (if present)
into the rear (socket) of the DigiConnector™.
Place the DigiSender™ transmitter on a flat
surface near to your source equipment. Avoid
placing the transmitter directly on top of other
electrical devices (see troubleshooting guide)
Connect DigiConnector™ 2 into your VCR or
DVD. Where available, use SCART sockets labelled
OUT or TV. Connect any existing SCART lead in to
the rear socket of the DigiConnector™
The Contrast A/B
switch is present
to compensate
for differences in
equipment/set-
ups.
Once installation
is complete, if
you experience a
poor picture then
adjust the A/B
setting.
LIVING ROOM
LIVING ROOM
LIVING ROOM
The DigiSender™ X7 features 4 audio/video channels and 4 primary remote relay
channels. For the unit to function correctly the audio/video channel must be set
the same on both the transmitter and receiver. Also, the remote relay channel
must be the same on both the transmitter and receiver.
Page 19
Please read this instruction manual carefully prior to installation
DG440 DigiSender™ X7
Audio/Video Channel
Remote Relay Channel
Channel 1 Channel 2 Channel 3 Channel 4
ON
OFF
OFF
OFF
OFF
ON
OFF
OFF
OFF
OFF
ON
OFF
OFF
OFF
OFF
ON
1
2
3
4
Receiver Channel Settings
Transmitter Channel Settings