User manual

9. HINTS AND TIPS
9.1 Ecological hints
• Spin the laundry well before drying.
• Do not exceed the load sizes which
are specified in the programs chapter.
• Clean the filter after each drying
cycle.
• Do not use fabric softener to wash
and then dry. In the tumble dryer
laundry becomes soft automatically.
• Use distilled water like that used for
steam ironing. If it is necessary, clean
the distilled water before (e.g. with a
coffee filter) to remove any particles.
• Always keep the airflow slots at the
bottom of the appliance clear.
• Make sure there is good airflow where
the appliance is to be installed.
9.2 Adjustment of default
dryness level
To change the default dryness level:
1. Turn the appliance on.
2. Select 1 of the available programs.
3. Touch and hold down the
Dryness and Anticrease buttons
at the same time.
One of the symbols appears on the
display:
- Maximum dryness
- Extra dryness
- Standard dryness
4. Touch the
Start/Pause button
repeatedly until you reach the
desired dryness level.
Dryness lev-
el
Display symbol
Maximum
dryness
Dryness lev-
el
Display symbol
Extra dry-
ness
Standard
dryness
5. To memorise the setting touch and
hold down the
Dryness and
Anticrease buttons at the same time
for approximately 2 seconds.
9.3 Deactivating the tank
indicator
The water container indicator is activated
by default. It illuminates at the end of the
drying cycle or during the cycle if the
water reservoir is full. If the draining kit is
installed the water container is drained
automatically and the indicator can be
deactivated.
To deactivate the indicator:
1. Turn the appliance on.
2. Select 1 of the available programs.
3.
Touch and hold down Anticrease
and Time Dry buttons at the
same time.
One of 2 configurations is possible:
• the Tank indicator:
is on if the
symbol
appears - the
water container indicator is
permanently activated
• the Tank indicator: is off if the
symbol appears - the
water container indicator is
permanently deactivated
www.aeg.com
16