User manual

• Clean the primary filter after each dry-
ing cycle.
• Clean the heat exchanger filters when
the applicable indicator comes into
the view on the control panel.
• Spin good the laundry before drying.
8.2 Adjustment of the
remaining laundry moisture
degree
To change the default degree of the re-
maining moisture of the laundry:
1.
Turn the programme dial to availa-
ble programme.
2.
Push at the same time the Dry Plus
and the Anticrease buttons. Hold
down until one of the symbols go in-
to view on the display:
–
the maximum dry laundry
–
the more dry laundry
–
the default dry laundry
3.
Push the Start Pause button again
and again until you set necessary
level.
4.
To memorise the setting push at the
same time the Dry Plus and the Anti-
crease buttons.
8.3 Water container full —
indication
By default the indication LED is always
on. It comes into the view at the end of
the cycle or when the water container is
full. When you use an external equip-
ment to drain the container, the LED can
be off.
To activate or deactivate the indication:
1.
Turn the programme dial to availa-
ble programme.
2.
Push at the same time the Dry Plus
and Buzzer buttons and hold down
until you see the correct setting:
– the LED is off and the symbol
goes into the view - The
LED is permanently off
– the LED is on and the symbol
goes into the view - The
LED is activated
9. CARE AND CLEANING
9.1 Cleaning the primary filter
At the end of each cycle the applicable
indicator (clean the primary filter) is on to
tell you that the primary filter must be
cleaned.
The filter collects the fluff. The
fluff occurs while the cloths are
dried in the tumble dryer.
To clean the primary filter:
1.
Open the door.
2.
Pull the filter.
ENGLISH 13