User manual

High water hardness.
Set applicable water hardness
4)
.
Door does
not close
Filter not locked in position.
Put the filter in the correct posi-
tion.
Laundry locked between the
door and the seal.
Put the load correctly in the
drum.
Err (Error)
on the dis-
play.
5)
Attempt to change parameters
after start of the programme.
Turn the tumble dryer off and
on. Set requested parameters.
The function you set is not ap-
plicable with the set programme
Turn the tumble dryer off and
on. Set requested parameters.
No drum
light
6)
Defective drum light.
Contact the service centre to re-
place the drum light.
Abnormally
elapsing
time on the
display
5)
Time to end is calculated on the
basis of: type, volume and
dampness of laundry.
Automatic procedure; this is not
a appliance fault.
Drying cycle
too short
Small laundry volume./Too dry
laundry for selected pro-
gramme.
Select time programme or high-
er drying level (e.g. Extra Droog
(Extra dry) ).
Drying cycle
too long
7)
The filter clogged. Clean the filter.
Too high volume of the load.
Respect the maximum load vol-
ume.
Laundry insufficiently spun. Spin adequately the laundry.
Very high room temperature -
no appliance fault.
Lower the room temperature if
possible.
1)
In case of error message on the display (e.g. E51- only tumble dryer with the display):
Switch the tumble dryer off and on. Set programme. Push the Start/Pauze (Start/Pause)
button. Does not work? - inform local service and quote the error code.
2)
follow programme recommendation - see PROGRAMMES chapter
3)
see CARE AND CLEANINGchapter
4)
see section MACHINE SETTINGS in HINTS AND TIPS chapter
5)
only dryers with the display
6)
Only dryers with drum light.
7)
Note: After maximum 5 hours the drying cycle ends automatically (see Drying cycle
complete section).
DRUM LIGHT
Only use a special bulb which is de-
signed specially for tumble dryers. The
special bulb can be obtained from your
local service centre.
WARNING!
When the appliance is switched
on, the interior lighting switches
itself off after 4 minutes when
the door is open.
WARNING!
Do not use standard bulbs!
These develop too much heat
and may damage the appliance!
Before you replace the bulb,
disconnect the mains plug; with
a permanent connection: fully
unscrew or deactivate the fuse.
1. Unscrew cover above the bulb (this
can be found directly behind the
loading aperture, at the top; refer to
38