User manual

the indicator: End is on - the maximum
dry laundry is set
6. To memorise the setting, push at the
same time the Reverse Plus and
Anti-crease buttons for
approximately 2 seconds.
10.3 Deactivating the Water
container indicator
1. Turn on the appliance.
2. Wait approximately 8 seconds.
3. Select 1 of available programmes.
4. Push at the same time and hold
down the Reverse Plus and
Delay Start buttons.
LEDs above the buttons flash 3 times.
One of 2 configurations is possible:
• the Water container indicator:
is on - the water container
indicator is permanently on
• the
Water container indicator:
is off - the water container
indicator is permanently off
11. CARE AND CLEANING
11.1 Cleaning the filter
At the end of each cycle the indicator
Filter is on and you must clean the filter.
The filter collects the fluff.
The fluff occurs while the
cloths are dried in the
tumble dryer.
1. Open the door. Pull the filter.
2. Push the hook to open the filter.
3. Use a moist hand to clean both parts
of the filter.
4. If necessary clean the filter with the
brush under warm tap water and/or a
vacuum cleaner. Close the filter.
5. If necessary remove fluff from the
filter socket and gasket. You can use
a vacuum cleaner. Put the filter inside
the filter socket.
ENGLISH
15