Operation Manual

6
6.3 Set flash time
This telephone gives you the possibility to use the special services of your network provider.
When pressing the flash button
, the phone generates a line interruption and the length depends
on your flash time setting.
tIn standby mode, press the set button
.
>The display shows “SET 1 DATE”.
>Press the up or down button
until the display shows “SET 3 FLASH”.
tPress the store button
to confirm.
tPress the up or down button
to select 100 (default), 300, 600, or 1000.
tPress the store button
to confirm the setting.
>The display shows “SET 1 DATE”, you can continue with programming or press the delete button
to return to standby mode.
7 TELEPHONE OPERATIONS
7.1 Making a call
tLift the handset and listen for a dial tone.
>The display shows “00-00”.
tDial the telephone number.
>The display shows the number as you dial (maximum of 14 digits will be shown)
tTo end the call, return the handset to the base unit.
7.2 To answer a call
When the phone rings:
tLift the handset or press the speakerphone button
on the base unit.
>The call timer starts about 7 seconds after going on line.
7.3 To adjust the speakerphone volume
During a call:
Adjust the volume of the speakerphone to your comfortable volume level using the speakerphone
volume.
7.4 To end a call
tReplace the handset on the base unit cradle or press the speakerphone button
on the base unit.
>The speakerphone light indicator will turn off.
7.5 To switch between the handset and the speakerphone
tDuring a phone conversation through the handset, press the speakerphone button
to speak
hands-free.
>Then the speakerphone light will turn on, but the conversation remains through the handset until
the handset is replaced on the base unit cradle.
>While in speakerphone mode, lift the handset to enable a private conversation.