SKS71200F0 EN REFRIGERATOR USER MANUAL
FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler – features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it. ACCESSORIES AND CONSUMABLES In the AEG webshop, you’ll find everything you need to keep all your AEG appliances looking spotless and working perfectly.
Contents 3 CONTENTS 4 6 9 10 11 11 13 15 15 17 19 Safety information Control panel First use Daily use Helpful hints and tips Care and Cleaning What to do if… Technical data Installation Noises Environmental concerns The following symbols are used in this user manual: Important information concerning your personal safety and information on how to avoid damaging the appliance.
Safety information SAFETY INFORMATION In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features.
Safety information 5 – thoroughly ventilate the room in which the appliance is situated • It is dangerous to alter the specifications or modify this product in any way. Any damage to the cord may cause a short-circuit, fire and/or electric shock. WARNING! Any electrical component (power cord, plug, compressor) must be replaced by a certified service agent or qualified service personnel to avoid hazard. 1. 2. • • • • Power cord must not be lengthened.
Control panel • It is advisable to wait at least four hours before connecting the appliance to allow the oil to flow back in the compressor. • Adequate air circulation should be around the appliance, lacking this leads to overheating. To achieve sufficient ventilation follow the instructions relevant to installation. • Wherever possible the back of the product should be against a wall to avoid touching or catching warm parts (compressor, condenser) to prevent possible burn.
Control panel 7 Display 7 1 1 2 3 4 5 6 7 2 3 4 5 6 Timer function COOLMATIC function Minute Minder function Child Lock function Alarm indicator Temperature indicator Holiday function Switching on To switch on the appliance do these steps: 1. Connect the mains plug to the power socket. 2. Press the ON/OFF button if the display is off. 3. The alarm buzzer could operate after few seconds. To reset the alarm refer to "High temperature alarm". 4.
Control panel Minute Minder function The Minute Minder function is to be used to set an acoustic alarm at the preferred time, useful for example when a recipe requires to cool down a mixture for a certain lenght of time. To switch on the function: 1. Press the Mode button until the corresponding icon appears. The Minute Minder indicator flashes. The Timer shows the set value (30 minutes) for a few seconds. 2. Press the Timer regulator button to change the Timer set value from 1 to 90 minutes. 3.
First use 9 The COOLMATIC indicator is shown. The COOLMATIC function shuts off automatically after approximately 6 hours. To switch off the function before its automatic end: 1. Press the Mode button until the COOLMATIC indicator flashes. 2. Press the OK button to confirm. 3. The COOLMATIC indicator goes off. The function switches off by selecting a different fridge set temperature.
Daily use Do not use detergents or abrasive powders, as these will damage the finish. If “dEMo” appears on the Display, the appliance is in demonstration mode: refer to “WHAT TO DO IF...” paragraph. DAILY USE Movable shelves The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. For better use of space, the front half-shelves can lie over the rear ones.
Helpful hints and tips 11 HELPFUL HINTS AND TIPS Hints for energy saving • Do not open the door frequently or leave it open longer than absolutely necessary. • If the ambient temperature is high and the Temperature Regulator is set to low temperature and the appliance is fully loaded, the compressor may run continuously, causing frost or ice on the evaporator. If this happens, set the Temperature Regulator toward warmer settings to allow automatic defrosting and so a saving in electricity consumption.
Care and Cleaning Do not pull, move or damage any pipes and/or cables inside the cabinet. Never use detergents, abrasive powders, highly perfumed cleaning products or wax polishes to clean the interior as this will damage the surface and leave a strong odour. Clean the condenser (black grill) and the compressor at the back of the appliance with a brush. This operation will improve the performance of the appliance and save electricity consumption. Take care of not to damage the cooling system.
What to do if… 13 WHAT TO DO IF… WARNING! Before troubleshooting, disconnect the mains plug from the mains socket. Only a qualified electrician or competent person must do the troubleshooting that is not in this manual. There are some sounds during normal use (compressor, refrigerant circulation).
What to do if… Problem The temperature in the appliance is too low/high. The temperature in the refrigerator is too high. Possible cause Solution Products prevent that water flows into the water collector. Make sure that products do not touch the rear plate. The temperature regulator is not set correctly. Set a higher/lower temperature. The door is not closed correctly. Refer to "Closing the door". The product temperature is too high.
Technical data 15 TECHNICAL DATA Dimension of the recess Height 1225 mm Width 560 mm Depth 550 mm Voltage 230-240 V Frequency 50 Hz The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. INSTALLATION Positioning WARNING! If you are discarding an old appliance that has a lock or catch on the door, you must ensure that it is made unusable to prevent young children being trapped inside.
Installation 1 5 2 3 4 The wires in the mains lead are coloured in accordance with the following code: 1 Green and Yellow: Earth 3 Brown: Live 5 Blue: Neutral As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: 1. Connect the wire coloured green and yellow to the terminal marked either with the letter “E“ or by the earth symbol or coloured green and yellow. 2.
Noises 17 Ventilation requirements The airflow behind the appliance must be sufficient. 50 mm min. 200 cm2 min. 200 cm2 NOISES There are some sounds during normal running (compressor, refrigerant circulation).
Noises BRRR! BLUBB! HISSS! SSSRRR! BRRR! BLUBB! HISSS! SSSRRR!
Environmental concerns CRACK! 19 CRACK! ENVIRONMENTAL CONCERNS The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment.
www.aeg.