User manual

Problem Possible cause Solution
Many food products were
put in at the same time.
Wait few hours and then check
the temperature again.
The room temperature is
too high.
Refer to climate class chart on
the rating plate.
Food products placed in
the appliance were too
warm.
Allow food products to cool to
room temperature before stor-
ing.
The door is not closed cor-
rectly.
Refer to "Closing the door".
The "Frostmatic function"
or "Coolmatic function" is
switched on.
Refer to "Frostmatic function"
or "Coolmatic function".
There is too much frost and
ice.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
Refer to "Closing the door".
Temperature is set incor-
rectly.
Refer to "Operation" .
The compressor does not
start immediately after
pressing the "Frostmatic" or
"Coolmatic", or after chang-
ing the temperature.
This is normal, no error has
occurred.
The compressor starts after a
period of time.
Water flows inside the refrig-
erator.
Food products prevent the
water to flow into the wa-
ter collector.
Make sure that food products
do not touch the rear plate.
Temperature cannot be set. The "Frostmatic function"
or "Coolmatic function" is
switched on.
Switch off "Frostmatic func-
tion" or "Coolmatic function"
manually, or wait until the
function resets automatically
to set the temperature. Refer
to "Frostmatic function" or
"Coolmatic function".
dEMo appears on the dis-
play.
The appliance is in demon-
stration mode.
Keep the OK pressed for ap-
proximately 10 seconds until a
long sound is heard and dis-
play shuts off for a short time.
The temperature in the ap-
pliance is too low/too high.
The temperature regulator
is not set correctly.
Set a higher/lower tempera-
ture.
The door is not closed cor-
rectly.
Refer to "Closing the door".
www.aeg.com16