User manual

8
Türanschlag wechseln
Der Türanschlag kann von rechts (Lieferzustand) nach links gewechselt wer-
den, falls der Aufstellort dies erfordert.
Warnung! Während des Türanschlagwechsels darf das Gerät nicht am
Stromnetz angeschlossen sein. Vorher Netzstecker ziehen.
A
B
NP005
100 mm10 mm
10 mm
Hintere Abstandstücke
Im Beipack sind 2 Distanzstücke
enthalten, die wie in der Abbildung
gezeigt montiert werden müssen.
Lösen sie dazu etwas die Schrauben der
Gehäauseabdeckung. Schieben sie das
Distanzstück unter den Schraubenkopf
und ziehen Sie die Schraube wieder
fest.
PR153
Vorgehensweise
1. Sockelblende (D) nach vorn
abziehen.
2. Türlagerabdeckung (F) von links nach
rechts umsetzen.
3. Unteres Türlager (E) abschrauben.
4. Kühlraumtür nach unten abnehmen.
E
F
D
F
F
F
Ihr Kühlgerät braucht Luft
Aus Gründen der Sicherheit muß
eine Mindestbelüftung gesichert
sein, wie aus der Abb. hervorgeht:
Achtung:
Die Lüftungs-Öffnungen müssen
immer saubergehalten werden.
Damit die Luft zirkulieren kann, die
Lüftungsöffnungen niemals
Abdecken oder verstellen.
41
Warning!
• The appliance may not be connected to the mains during cleaning. Dan-
ger of electrical shock! Before cleaning switch the appliance offand rem
ve the plug from the mains, or switch off or turn out the circuit breaker
or fuse.
• Never clean the appliance with a steam cleaner. Moisture could accumu-
late in electrical components, danger of electrical shock! Hot vapours can
lead to the damage of plastic parts.
• The appliance must be dry before it is placed back into service.
Attention!
• Ethereal oils and organic solvents can attack plastic parts, e.g.
– lemon juice or the juice from orange peals;
– butyric acid;
– cleansers which contain acetic acid.
Do not allow such substances to come into contact with appliance parts.
• Do not use any abrasive cleansers.
1. Remove frozen food and the food from the refrigerator. Wrap frozen food
in several layers of newspaper. Store it in a cool place, well covered.
2. Defrost the freezer compartment prior to cleaning (see "Defrosting" sec-
tion).
3. Switch the appliance off and remove the plug from the mains, or switch
off or turn out the circuit breaker or fuse.
4. Clean the appliance and the interior accessories with a cloth and lukewarm
water. Commercially available dish washing detergents may also be used.
5. After cleaning wipe with fresh water and rub dry.
Accumulation of dust at the condenser increases energy consumption. For
this reason carefully clean the condenser at the back of the appliance once
a year with a soft brush or a vacuum cleaner.
6. Check the water drain hole on the rear wall of the fridge. Clear a blocked
drain hole with the aid of the green peg included with the appliance.
7. After everything is dry place appliance back into service.
Energy Saving Tips
• Do not install the appliance near cookers, radiators or other sources of
warmth. High ambient temperatures cause longer, more frequent opera-
tion of the compressor.
• Ensure sufficient air circulation and exhaust at the appliance base and at
the back wall of the appliance. Never cover air vent openings.