User manual

Problem Possible cause Solution
The compressor does not
start immediately after
pressing the FROSTMATIC
or after changing the tem-
perature.
This is normal, no error has
occurred.
The compressor starts after
some time.
The compressor does not
start immediately after
pressing the COOLMATIC
or after changing the tem-
perature.
This is normal, no error has
occurred.
The compressor starts after
some time.
Water flows inside the re-
frigerator.
The water outlet is clog-
ged.
Clean the water outlet.
Food products prevent wa-
ter from flowing into the
water collector.
Make sure that food products
do not touch the rear plate.
Water flows on the floor. The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor.
Attach the melting water out-
let to the evaporative tray.
Temperature cannot be set. The FROSTMATIC or
COOLMATIC function is
switched on.
Switch off FROSTMATIC or
COOLMATIC manually, or wait
until the function resets auto-
matically to set the tempera-
ture. Refer to "FROSTMATIC
or COOLMATIC function".
DEMO appears on the dis-
play.
The appliance is in demon-
stration mode.
Keep the mode key pressed
for approximately 10 seconds
until a long sound is heard and
display shuts off for a short
time.
The temperature in the ap-
pliance is too low/too high.
The temperature regulator
is not set correctly.
Set a higher/lower tempera-
ture.
The food products temper-
ature is too high.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Many food products were
stored at the same time.
Store less food products at the
same time.
The FROSTMATIC function
is switched on.
Refer to "FROSTMATIC func-
tion".
The COOLMATIC function
is switched on.
Refer to "COOLMATIC func-
tion".
ENGLISH 11