Washer User Manual

Setting up and connection instructions

Prepare the Installation Location

• The installation surface must be clean, dry and free of floor wax resi-

due and other lubricating coatings so that the unit does not slide

away. Do not use any lubricants as sliding aids.

• It is not recommended to set up the washing machine on deep-pile

carpets or on floor coverings with soft foam underlays, as this would

mean that the stability of the unit would not be guaranteed.

• Use ordinary rubber mats as underlays in locations with small-format

tiles.

• Never use wood, card or similar underlays to compensate for minor

floor unevenness. Always use the adjustable screw-type feet of the

machine.

• If, for reasons of space, it is not possible to avoid setting up the unit

next to a gas cooker or coal stove: Insert a thermally-insulating panel

between the washing machine and the cooker (85 x 57cm). This panel

must have an aluminium foil on the side against the cooker.

• The washing machine must not be set up in a room where there

is a danger of frost. Frost damage!

• The intake and drainage hoses must not be bent or pinched.

Setting Up on a Concrete Pedestal

When setting up the washing machine on

a concrete pedestal, it is essential for

safety reasons to fit stand plates in which

the washing machine is then adjusted.

The stand plates are available from the

Customer Service under spare part

number 645 425 058.

Setting Up on a Vibrating floor

In the case of vibrating floors, especially wooden beam floors with flex-

ible boards, securely screw a water-resistant wooden panel at least

15mm thick onto at least 2 of the floor beams. If possible, set up the

unit in a corner of the room where the wooden floor is best firmly in-

stalled and is therefore least likely to be susceptible to vibrations.