User manual

3. Put the detergent and the additives
in the appropriate compartment.
4. Turn the programme dial to the
washing programme. The display
shows the default temperature and
spin. If necessary, change them
according to your laundry. The
display also shows the maximum
recommended load for washing
phase.
5. Set the desired options, if there are
available.
6. Touch the 模式 button once to
activate also the drying function. The
洗衣 and 干衣 indicators come on.
The indicators and
appear on the display. The display
also shows the maximum
recommended load for a washing
and drying programme (e.g. 6 kg for
cottons).
When drying a large laundry
load, make sure that the
garments are not rolled up
and that are uniformly
distributed in the drum.
At the beginning of the
drying cycle (3 - 5 minutes), a
slightly higher noise can be
heard. This is caused by the
compressor and it is quite
normal for compressor
powered appliances such as
refrigerators, freezers and so
on.
11.2 Washing and Drying -
Automatic levels
1. Tap on the 自动烘干 button
repeatedly until the display shows
the required dryness level. The
indicators in the display illuminate
accordingly:
a. Iron dry: for cotton
items;
b. Cupboard dry: for
cotton and synthetic items;
c. Extra dry: for cotton
items.
The time value on the display is the
duration of both cycles washing and
drying.
To have a good drying by
using less energy and in a
shorter time, the appliance
does not let you set a too
low spin speed for the items
to be washed and dried.
2. Touch button 启动/暂停 to start the
programme. The ProSense
estimation starts.
In the display the door locked
indicator goes on, the indicator of the
running phase starts flashing.
The display also shows the remaining
programme time.
11.3 Washing and Timed
Drying
1. Tap on the button 定时烘干
repeatedly to set the desired time
value (see the "Timed drying" table
the "Programmes" chapter). The
drying level indicator goes off and
the indicator comes on.
The minimum timed drying is 10 minutes.
Each time you tap on this button the
time value increases by 5 minutes. The
display shows the set new time value.
2. Touch the 启动/暂停 to start the
programme. The ProSense
estimation starts.
In the display the door locked
indicator comes on and the indicator of
the running phase starts flashing.
The display also shows the remaining
programme time.
11.4 At the end of the drying
programme
• The appliance stops automatically.
• The acoustic signals operate (if they
are active).
• In the display comes on.
• The indicator of button 启动/暂停
goes off. The door locked goes
off
• Press the button 开/关 for some
seconds to deactivate the appliance.
ENGLISH 29