User manual
Table Of Contents
- CONTENTS
- 1. SAFETY INFORMATION
- 2. SAFETY INSTRUCTIONS
- 3. INSTALLATION
- 4. PRODUCT DESCRIPTION
- 5. CONTROL PANEL
- 6. DIAL AND BUTTONS
- 7. PROGRAMMES
- 8. BEFORE FIRST USE
- 9. SETTINGS
- 10. DAILY USE
- 10.1 Activating the appliance
- 10.2 Loading the laundry
- 10.3 Filling the detergent and additives
- 10.4 Check the position of the flap
- 10.5 Setting a programme
- 10.6 Starting a programme
- 10.7 Starting a programme with the delay start
- 10.8 The ProSense load detection
- 10.9 Programme phase indicators
- 10.10 Interrupting a programme and changing the options
- 10.11 Cancelling a running programme
- 10.12 Opening the door - Adding garments
- 10.13 End of the programme
- 10.14 Draining water out after end of cycle
- 10.15 Stand-by option
- 11. DAILY USE - WASHING & DRYING
- 12. DAILY USE - DRYING ONLY
- 13. FLUFF IN THE FABRICS
- 14. HINTS AND TIPS
- 15. CARE AND CLEANING
- 16. TROUBLESHOOTING
- 17. TECHNICAL DATA
- 18. ACCESSORIES
10.14 Draining water out after
end of cycle
If you have chosen a programme or an
option that does not empty out the
water of the last rinse, the programme is
completed, but:
•
The display shows the indicator
, the
option indicator or and the
door locked indicator . The
indicator of the running phase
flashes.
•
The drum still turns at regular intervals
to prevent the creases in the laundry.
• The door stays locked.
• You must drain the water to open the
door:
1. If necessary, touch the 脱水 button to
decrease the spin speed proposed
by the appliance.
2. Touch the 启动/暂停 button:
• If you have set
, the appliance
drains the water and spins.
•
If you have set
, the appliance
only drains the water.
The option indicator or goes out,
while the indicator flashes and then
goes off.
3. When the programme is completed
and the door locked indicator
goes off, you can open the door.
4. Press the 开/关 button a few seconds
to deactivate the appliance.
In any case, the appliance
empties the water out
automatically after
approximately 18 hours.
10.15 Stand-by option
The Stand-by function automatically
deactivates the appliance to decrease
the energy consumption when:
•
You do not use the appliance for 5
minutes before you touch the 启动/暂
停 button.
Press the button 开/关 to activate the
appliance again.
• After 5 minutes from the end of the
washing programme
Press the 开/关 button to activate the
appliance again.
The display shows the end of the last
set programme.
Turn the programme dial to set a new
cycle.
If you set a programme or an
option that ends with water
in the drum, the Stand-by
function doesn't deactivate
the appliance to remind you
to drain the water.
11. DAILY USE - WASHING & DRYING
WARNING!
Refer to Safety chapters.
This appliance is an
automatic washer dryer.
11.1 NON-STOP programme -
Wash and dry
Not all programmes are
compatible with drying
function. The 连续洗干
programme is already a
complete wash&dry
programme.
You can wash and dry your laundry
setting a «non stop-programme».
Proceed as follows:
1. Press the 开/关 button for some
seconds to activate the appliance.
2. Load the laundry one item at a time.
www.aeg.com28