User manual

21
Changing bulb for inside light
Only use a special bulb which is designed specially for dryers. The spe-
cial bulb is available from the after-sales service,
ET-Nr. 112 552 000-5.
1 Warning! Do not use standard bulbs! These develop too much heat and
may damage the machine!
1 Warning! Before replacing the bulb, disconnect the mains plug; with a
permanent connection: fully unscrew or deactivate the fuse.
1. Unscrew covering bonnet from above bulb (this can be found directly
behind the loading aperture, at the top; refer to “Description of ma-
chine” section.)
2. Replace defective bulb.
3. Screw covering bonnet back down.
1 Warning! For reasons associated with safety, the covering bonnet must
be screwed down tightly. If this is not done, the dryer must not be op-
erated.
Drying cycle ends
shortly after pro-
gramme starts. E END
display illuminated.
Not enough washing load-
ed or washing loaded is too
dry for selected programme.
Select time programme or
higher drying level (e.g.
N INTENSIVE DRY instead of
» STORAGE DRY).
Drying cycle lasts an
unusually long time.
Note:
After around 5 hours
the drying cycle ends
automatically (see
„Drying cycle com-
plete“).
Lint filter clogged. Clean lint filter.
Heat exchanger clogged
with lint.
Clean heat exchanger.
& SPECIAL CARE button
pressed and load volume too
big.
& SPECIAL CARE is only suita-
ble for use with loads of up to
3kg!
Load volume too big. Reduce load volume.
Laundry insufficiently pre-
drained.
Laundry must be adequately
pre-drained.
Problem Possible cause Remedy