User manual

• In a sink drain pipe with a trap.

The drain hose can be connected directly in-

to the pipe (e.g. beneath a washtub or sink),

above the water trap. The drain hose must

be arranged so that some part of it’s length

is routed up to a level corresponding to the

top edge of the tub and fixed in place there.

• Directly into a drain pipe at a height of not

less than 65 cm and not more than 80 cm.

Their must be an air gap around and below

the end of drain hose. This means that the

internal diameter of the standpipe must be

larger than the outer diameter of the hose.

The hose must not be sticked into the stand-

pipe more than 50 mm and it has to be fixed

in this position. The drain hose must not be

kinked.

The drain hose may be extended to a maximum of 3,5 m. An additional drain hose and join-

ing piece is available from your local Service Centre.

WARNING!

In order for the machine to function properly ,the drain hose must be hooked on the facto-

ry fitted support piece situated on top of the rear side of the appliance.

ELECTRICAL CONNECTION

WARNING!

Any electrical work required to install this appliance must be carried out by qualified

electrician or competent person.

Information on the electrical connection is given on the rating plate on the inner edge of

the appliance door.

650-800 mm

40 mm

28 Electrical connection