User manual

9. WHAT TO DO IF…
Certain problems are due to lack of sim-
ple maintenance or oversights, which
can be solved easily without calling out
an engineer. Before contacting your lo-
cal Service Centre, please carry out the
checks listed below.
During machine operation it is possible
that the End pilot light blinks to indicate
that the machine is not working:
• 1 flash: problem with the water sup-
ply.
• 2 flashes: problem with the water
draining.
• 4 flashes: door open.
Once the problem has been eliminated,
press the button START to restart the
programme. If after all checks, the prob-
lem persists, contact your local Service
Centre.
Problem Possible cause/Solution
The machine does not
start:
The door has not been closed.
• Close the door firmly.
The plug is not properly inserted in the power sock-
et.
• Insert the plug into the power socket.
There is no power at the socket.
• Please check your domestic electrical installation.
The main fuse has blown.
• Replace the fuse.
The selector dial is not correctly positioned and the
button Start has not been pressed.
• Please turn the selector dial and press the button
Start again.
The delay start has been selected.
• If the laundry are to be washed immediately, can-
cel the delay start.
The machine does not
fill:
The water tap is closed.
• Open the water tap.
The inlet hose is squashed or kinked.
• Check the inlet hose connection.
The filter in the inlet hose is blocked.
• Clean the water inlet hose filter.
The door is not properly closed.
• Close the door firmly.
The machine fills then
empties immediately:
The end of the drain hose is too low.
• Refer to relevant paragraph in «Installation» chap-
ter.
ENGLISH 19