User manual

Installation and connection instructions

Electrical connection

Details of the mains voltage, current

type and required fuses can be

found on the rating plate. The ra-

ting plate is located at the top

above the filling door.

For permanent electrical connection

within the electrical circuit, provi-

sions must be made which allow for electrical disconnection of the ap-

pliance from the mains with a contact opening of at least 3 mm at all

poles. Suitable devices include circuit breakers, fuses (threaded fuses

must be entirely removed from the socket), ground fault circuit inter-

rupters and contactors. Permanent connection may only be carried out

by an authorised electrician.

;

This appliance complies with the following EC directives:

– The "Low Voltage Directive" 72/23/EU with changes

– The "EMC Directive" 89/336/EU with changes

Water connection

The washing machine has safety features which prevent back-contami-

nation of the drinking water and which conform to the national regu-

lations of the water authorities (e.g. for Germany: DVGW guidelines).

This means that additional protective measures in the installation are

not necessary.

Important!

– Units for connecting to cold water must not be connected to hot wa-

ter.

– Use only new hose sets for the connection.

Permissible water pressure

The water pressure must be at least 1 bar (= 10 N/cm

= 0.1 Mpa), max-

imum 10 bar = 100 N/cm

= 1 Mpa).

• If more than 10 bar: Connect a pressure-reduction valve upstream.

• If less than 1 bar: Unscrew the inlet hose on the unit side at the sole-

noid intake valve and remove the flow regulator (to do this, remove

the filter with pointed pliers and take out the rubber washer behind).

Replace the filter.